交通信号资料翻译-中英对照
TRAFFIC SIGNALS
第一部分总则PART 1 --- GENERAL
1.1工作描述DESCRIPTION OF WORK
A.交通信号的范围必须在图纸上标明，包括所有材料、设备、制造和劳力；交通标准包括交通信号，交通信号控制人员、信号杆、基础、加强混凝土导管过街道装置，以及需要的导线和电缆。显眼的交叉处比较皇家委员会的交通控制控制系统较为扩大，并且承包商必须提供所有comp主题h II的电电信连接控制装置的文件，要求为最新修正版本。The extent of the traffic signals is indicated on the drawings and includes the provision of all materials, equipment, fabrication, labor and transportation complete, including traffic signals, traffic signal controllers, signal poles, foundations, reinforced concrete duct bank street crossings, wiring and cables required. Signalized intersections shall be compatible wit an expansion of the existing Royal Commission Area Traffic Control System and Contractor shall provide all required electrical telecommunications connections for comp h II comply with the Control Devices, latest revision.
B.相关工作Related Work
1.第02200 部分土方工程。Section 02200 Earthwork
2.第03300 部分现场浇注混凝土。Section 03300 Cast-In-Place Concrete
3.第16050 部分基础材料和方法 – 电气Basic Materials and Methods - Electrical
1.2质量保证QUALITY ASSURANCE
A.规则和标准：Codes and Standards
如下内容，如果适用时，管理工作必须予以执行，除非皇室委员会提出书面反对意见。无论合同中引用何种皇室委员会的参考条文，这些条文必须和在这份合同中相应美利坚合众国规则和标准相符，除非在合同另作说明。The following, as applicable, shall govern the manner in which the work is performed, unless and until the Royal Commission provides written direction to the contrary. Wherever references are made in this contract to Royal Commission codes, these codes shall be read along with the corresponding United States of America Codes and Standards current on the date of this contract, unless otherwise specified in the contract
B.材料和设备标准：Materials and Equipment Standards:
1. NEMA 国家电制造商协会。National Electrical Manufacturers Association
2. USDOT 美国运输部，采用相同的交通控制装置United States Department of Transportation, Manual on Uniform Traffic Control Devices
3. ANSI美国国家标准学会American National Standards Institute
4.ITE 交通工程师协会。Institute of Traffic Engineers
5.ASTM 美国试验和材料学会。American Society for Testing and Materials
6.AASHTO美国国家公路和运输协会AASHTO American Association of State
Highway and Transportation Officials
7.IEEE 电气和电子工程研究所。Institute of Electrical and Electronic Engineers
8.ICEA 绝缘电缆工程师协会。Insulating Cable Engineering Association
9.IMSA国际市政信号协会。International Municipal Signal Association
C.试验和验收标准：Tests and Acceptance Criteria
1.本地操作试验： 在安装完成之后，承包商必须指导本地运行试验，并且提交详细资料和测验结果给皇室委员会给审核。设备将作为完整的工作系统的示范作业，并且符合本文的描述。Local Operating Test: After completion of installation, the Contractor shall conduct local operating tests, and submit details and test results to the Royal Commission for review. The equipment shall be demonstrated to operate as a complete working system and in accordance with the requirements described herein
2.地区交通控制系统操作试验(由其它方)：承包商提供和安装的交通信号，由地区交通控制系统的O&M承包商(其它方)进行适当的进一步操作测试。在新信号的安装的最后验收前，要求取得令人满意的测验结果。承包商可以对现有的地区控制系统，通过适当的操作，对安装的设备采取必要改正或者修理。Area Traffic Control System operating Test (By Others): Traffic signals provided and installed by the Contractor will be further tested for proper operation by the Area Traffic Control System O&M Contractor (others). Satisfactory test results are required prior to final acceptance of the new signal installations. The Contractor shall make all necessary corrections or modifications to the equipment furnished and installed by him to achieve proper operation of the signals by the existing area control system
3.地接电阻测量：按照皇室委员会标准测量每根接地棒接地电阻。工程的完成时，提交每根接地棒接地电阻的书面材料给皇室委员会。Ground-Resistance Measurements: Measure and certify to Royal Commission ground-resistance for each ground rod. Submit in writing measured ground-resistance of each ground rod and grounding system to the Royal Commission upon completion of project
2012.11.25